This stereo power amplifier was developed as an answer to the question of how much sound quality can be refined while maintaining a high output that can drive all kinds of speakers.
The power supply employs a large toroidal transformer with a capacity of 1.2 kva per channel and a large-capacity capacitor, realizing the capability of sending 45 v pulses at a high current of 30A per channel at peak.
The interior is completely monaural construction, and high precision parts are carefully selected for use.
Especially, very thick pure copper cables are used for internal wiring.
The damping factor can be switched to 3 levels of NOM/LOW/HIGH by the switch on the rear panel, further enhancing the adaptability to speakers.
Type Stereo power amplifier
Circuit Class AB operation
Rated output (according to the FTC Act) 200W + 200W (8 Ohm, both channel drive, continuous sine wave 20 Hz to 20 kHz, THD 0.2% or less)
Maximum output voltage 45 v (per channel)
Maximum output current 30A (per channel)
Input impedance 20k Ohm
Input sensitivity 1V
Power 100 VAC, 50Hz/60Hz
Power consumption 180W (idle) 2.5 kW (2 O load, non-clip maximum output)
External dimensions Width 483x Height 266x Depth 620 mm
|Staat van artikel||Tweedehands|
|(excl. € 44,00 verzendkosten)|