CR Developments Romulus P1
Beschrijving / Description
Remus was a natural development in the CR product range, offering more power and larger dynamic range than the smaller Romulus amplifier.
Remus is configured as a power amplifier with no switchable inputs and is designed to match directly with our Carmenta or Kastor pre-amplifiers, although it will work well with any high quality pre-amplifier.
Although Remus has a dynamic quality, it retains the smooth response inherent in all CR amplifiers, reproducing the gentlest passage or most strident orchestration with equal ease.
Over-engineered internal electronics leave the amplifier unstressed even under the most demanding conditions. No expense was spared where component selection was concerned, with the best signal components being used throughout all critical paths leaving the audio untarnished and full of its original vitality.
Transformers, always a key component, are exceptionally large. Less conservative designers would probably use them in 200 Watt output stages!
With so much power in hand, loudspeaker selection is not critical and can match the listener's taste without worrying about sound level and dynamics.
Specificaties / Specifications
Configuration Class AB Output KT90 x 4
or
6550 x 4 Unpacked 430x170x370mm
Power Output 50 Watts RMS Pre-driver 5687 x 2 Packed 530x450x240mm
Response 20Hz-25KHz +/-2dB Phase Splitter 12AX7 x 2 Weight Net 18.5Kg
Distortion 0.2% 1W@1KHz
0.8% 25W@1KHz
0.9% 50W@1KHz Weight Gross 21Kg
Noise <5mV
Number of Inputs 1
Input Level
(for Rated Output) Line 1V
Load Impedance 8 Ohms
Power Consumption 550 Watts (max)
Line Voltage 115/230 Volts